Buy Bandage plaster 20smkh3m No. 2
  • Buy Bandage plaster 20smkh3m No. 2

Bandage plaster 20smkh3m №2

$15.44
Quantity

  • All payments are encrypted via SSL All payments are encrypted via SSL
  • Full Refund if you haven't received your order Full Refund if you haven't received your order

The gypsum bandage is intended for imposing external tires, gypsum dressings for fractures, for making splints, immobilizing in the treatment of diseases of bones and joints, for injuries of soft tissues and in other cases that require fixing of fixing plaster cast, as well as for making impressions of limbs in orthopedics.

1. It is recommended to use water at room temperature (about 20 degrees). Although it is possible to use water with a temperature of from 0 to +35 C (in extreme conditions).
2. The depth of the container with water for soaking should ensure complete vertical immersion of the roll.
3. Without releasing the bandage from your hand, lower it into the water, preferably vertically, to ensure full and quick air release from the roll, since the bandage is completely wetted in 1-2 seconds, for which special ingredients are included in its composition that accelerate this process. to facilitate the work with him.
4. Remove the bandage from the water, squeezing it slightly, without fear that the plaster mix will flow out. The required amount of gypsum will still remain on the bandage.
5. The time of condensation, after which the modeling and addition of water is unacceptable is 1.5... 2 minutes. after soaking. Primary strength occurs within 2... 3 minutes. Period from 5 to 7 min. characterized by intense heat.
The final strength comes after the complete drying of water from the plaster cast, which corresponds to a breaking load of 2.2 kgf in the sample (according to GOST 52162-2003, load of 1.4 kgf). The complete drying time depends on the environmental parameters and the temperature of the body on which the dressing is applied.

The bandage gypsum non-pouring is very hygroscopic, therefore it should be stored in conditions that exclude moisture in the package without damage.

Must remember!
weak spinning (leaving a large amount of water in the roll) during the soaking process results in a slightly longer setting and drying time;
strong spin (small amount of water) - to the difficulty of modeling.
The setting time of the plaster bandage is different for different manufacturers, but not more than 8-10 minutes. The fixing bandages of plaster bandages are applied only by medical specialists.

Gypsum bandage is a strip of gauze with medical gypsum 10.15 and 20 cm wide, 3.0 m long, rolled up in rolls and hermetically sealed with bacteriostatic and indifferent to the body plasticizer (usually imported pr-va or PVA). in plastic wrap for one bandage in the package. On each package a stencil is applied indicating the instructions for use, the condition and the shelf life of the product.
The density of bandages from 380-660 g / m2.

Packaging

In the package 2pcs.